Search the Community
Showing results for tags 'plaster moulds'.
Found 1 result
Hi, We have been doing the jigger for the first time and the pieces whatever we are making have a cracks in a same pattern in a same location, and we are using Terracotta clay to make the pieces and here I m attaching the cross sectional pieces of the molds., and in the molds I have few doubts and I would like to get clarified so that I can reduce the cracking doors one by one., Does the thick and thin portions of the molds absorbs water differently so that the pieces are cracking ? As you can see the picture of the pieces the cracks are happening in the place where the side wall is connecting with the curved edges, and the cracks are happening only with our terracotta clay and we have tried quite a lot of receipes to avoid cracks but nothing is helping out and the cracks are happening in the inside of the pieces and the outside wall is just fine. Also we have tried jiggering few pieces with our stoneware clay and we havent have any cracks in the stoneware. Does the uneven wall thickness is the reason to get the cracks ? Wi only the Terracotta is cracking and not the stoneware ? Wi the inner wall is cracking and it didnt extend to the outer wall ? Does it anything to do with the plasticity and the composition of the clay? As far as the design is concerned, we make sure theres no undercuts in the design and even the wall is not striaght and it has an angle of 10% for easy releasing., we used to have few issues with our clay body which I was working with Tom (Glazenerd) to solve the issue, but apart from that I would like to know what are the other possible reasons for the cracking.