Jump to content

Search the Community

Showing results for tags 'fumes'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Ceramic Arts Daily Forums
    • Forum FAQ & Help Topics
    • Studio Operations and Making Work
    • Clay and Glaze Chemistry
    • Equipment Use and Repair
    • Business, Marketing, and Accounting
    • Educational Approaches and Resources
    • Aesthetic Approaches and Philosophy
    • Int'l Ceramic Artists Network (ICAN) Operations and Benefits
    • Ceramic Events of Interest

Found 2 results

  1. Wondering if any of you have experienced corrosion/rust of metal objects in your kiln space. My kiln is set up with a bottom mounted vent in a climate controlled studio that has a consistent humidity of about 50%, but I'm experiencing corrosion of my paper cutter, triple beam balance, and several other metal pieces. I'm a little concerned that something caustic in the kiln's off-gassings is causing this and that I'm breathing this same air. I'd appreciate your input.
  2. I installed a skutt envirovent 2 several months ago to help deal with fumes when firing (especially wax resist). My studio is in my basement and as I've transitioned to being a full time potter, I'm firing 2 or 3 days a week. The fumes were definitely shortening my life. Lol Vent worked perfectly until about a week ago when I started noticing fumes again. And tonight the smell was so bad it woke me from a dead sleep to open all the windows (even though its snowing with 60mph wind). So, I'm sitting in my living room at 2am in a parka and bunny slippers hoping someone has some experience troubleshooting these vents. -outside there is still warm air actively blowing from the vent -ducting is still attached at plenum cup,the joint between the first piece of duct house and the extension, and up at the motor -checked the holes in kiln floor and lid after I first noticed the smell last week and none were obstructed. Plenum cup seated correctly around the floor holes -the two half shelves on the kiln floor are raised up and spaced with a gap between them. I did notice that my lid doesn't seem to really seal when closed. The gap seems to be where two bricks are a little lower than the others, but we're Talking like 1mm difference maybe. The kiln hasnt been moved or bumped though, so I don't see how that could have been a recent development, and like I said, the vent has worked fine for over a month. Any thoughts or suggestions on what to check?
×